emccx400磁阵安装手册

emccx400磁阵安装手册内容摘要：

nd enter the following URL: d. In the Storage Processor Network Configuration setup screen that appears, enter the following for SP A, as you specified earlier:  IP address 输入跟主机在同一个网段的，分配给 SPa 的 IP 地址，比如  Hostname 给 SPa 起一个容易记忆的名字，比如 CX400_SPa  Sub mask 输入该网段子网掩码 比如  Gateway address for SP A 输入网关，比如  Peer IP address for SP B 在这里输入同一个网段中，分配给 SPb 的 IP 地址，比如 You must enter a unique address in this field. The peer address is often an increment of the first address. For example, if SP A has an IP address of , then the peer IP address probably would be .  If you want, change the management port setting to 2162/2163. Otherwise, leave the management port setting on 80/443. 一般这里无须更改，保留默认端口号即 可 CAUTION: Be sure that this is the management port you want to set it to. If you want to change it back later you must remove the node from its domain before you can change its port setting from the default. If you do change the management port setting, you will need to append the URL with :2162 whenever you want to manage the array. e. Click Apply Settings. After about 30 seconds, a confirmation screen appears, listing the work configuration information you entered in the previous step. The confirmation screen also includes a message informing you that SP A is 20 rebooting. 点击 apply settings 之后系统提示你确认，按照提示确认以上修改，之后 SPa 将会重启，启动过程大概在 5 分钟左右。 （上图仅供参考，可能与安装环境略有区别） 拔掉连接到 SPa 的串口线，连接到 SPb Perform the following for SP B: f. On the laptop, select Start  Settings  Network and Dial up Connections. Select the connection name that。